Headset

NGENUITY should automatically swap back to the hardware audio endpoints when the software and audio engine are not running. Check Windows sound settings and make sure the following devices are assigned correctly to the hardware endpoints: Default playback device: Headphones (HyperX Cloud Alpha 2 Wir

Slide the mode switch to the Bluetooth icon. Press and hold the Power and Multifunction buttons for 2 seconds to enter Bluetooth pairing mode. Pairing mode is active when the LED blinks blue and the voice prompts says "Bluetooth pairing". ​ ​Go to your device Bluetooth settings, search, and connect

Setting up with Discord 1. In Discord settings, select Voice & Video. 2. Under Voice Settings, set Input Device to “Microphone (HyperX Cloud Flight S Chat)”. 3. Set Output Device to “Headset Earphone (HyperX Cloud Flight S Chat)”.

Usage (Mobile Device) To use the headset with a mobile device (or other device) with a headset jack (4 pole CTIA), connect the 3.5mm plug directly into the headset jack on your device.

The microphone can be positioned on either side of the earcup. Therefore, the headset can be used on the left and/or right ear.

1. Connect the wireless adapter to the PC. 2. Power on the headset. 3. Right click speaker icon > Select Open Sound settings > Select Sound Control Panel 4. Under the Playback tab, click on “HyperX Cloud Stinger 2 Wireless” and click on the Set Default button. 5. Under the Recording tab, click on “H

Usage (Xbox® One) To use the HyperX Cloud II headset with Xbox® One, you will need the Xbox One adapter (sold separately) that plugs into the Xbox® One controller (pictured below.) Because this adapter has built-in volume controls, you will remove the USB control box (that came with your HyperX Clou

The Cloud Alpha Wireless comes with dynamic, 50mm with neodymium magnets.

PlayStation 4 USB Setup 1. Power on the headset. 2. Hold down the microphone volume wheel for 2 seconds to change audio modes. Repeat this step until the headset plays the voice prompt “2 Channel”. 3. Connect the headset to the PlayStation 4 console with the USB Type-C to USB Type-A cable. 4. From t

Setting up with PC 1. Connect the wireless USB adapter to the PC. 2. Power on the headset. 3. Right click speaker icon > Select Open Sound settings > Select Sound Control Panel 4. Under the Playback tab, click on “HyperX Cloud Alpha Wireless” and click on the Set Default button. 5. Under the Recordi