HyperX Clutch Talon Battery Removal
Aktualisiert
1. Remove trigger pieces, rear paddles, and magnetic back plate
2. Remove the product sticker. 3 Torx 6 (T6) screws are located behind the sticker.
•2 T6 Screws are near the top magnet •1 T6 Screw in between P2 and P3
3. Grip the edge of the exposed trigger area and pull the side controller grip apart, going in the direction away from the controller, on both sides.
4. Remove the 2 T6 screws on each side
5. Gently pry and lift the controller’s back cover. Unhook the data cable from the controller board by lifting the black connector tab upward.
6. Unplug the battery connector
7. Remove the battery by lightly lifting upward to loosen the bottom adhesive. In a rocking motion, gently slide the battery towards you.
Do not bend past the plastic, else damage may occur to the battery or the controller.
8. Reverse directions to reassemble the controller. Check for alignment with the Connection Switch at the bottom when re-assembling