Cloud Alpha Wireless

The Cloud Alpha Wireless range is up to 20 meters *Wireless range may vary due to environmental conditions.

Overview A. Status LED B. Power Button C. Mic Mute / Mic Monitoring Button D. USB-C Charge Port E. Microphone Port F. Volume Wheel G. Detachable Microphone H. Microphone Mute LED I. USB Adapter J. Wireless Status LED K. Wireless Pairing Pin Hole L. USB Charge Cable

Controls Status LED *Battery level indication *The status LED will automatically turn off to conserve battery life Power Button Hold for 3 seconds to power headset on/off Press to hear battery level voice prompt Mic mute / mic monitoring button Press to toggle mic mute on/off LED On – Mic muted LED

1. Connect the wireless USB adapter to the PlayStation 5 console. 2. Go to the home page and select Settings > Sound 3. Under Microphone set the following: Input Device to USB Headset (HyperX Cloud Alpha Wireless) 4. Under Audio Output set the following: Output Device: USB Headset (HyperX Cloud Alph

*Advanced Troubleshooting. Do not attempt if you are unsure. We highly recommend reaching out to the HyperX support team for assistance. - Verify that the DTS APO service "DtsHpXV2Apo4Service" is running. Can be checked in Windows "Services" App. If DTS APO service is not running, try installing Vis

Cloud Alpha Wireless User Manual

Cloud Alpha Wireless Specifications Headphone Driver: Dynamic, 50mm with neodymium magnets Form factor: Over ear, circumaural, closed back Frequency response: 15 Hz – 21 kHz Impedance: 62 Ω Sensitivity: 103 dBSPL/mW at 1 kHz T.H.D.: ≤ 2% Frame type: Aluminum Ear cushions: Memory foam and premium lea

Charging the Headset It is recommended to fully charge your headset before first use. When charging the headset, the headset status LED will indicate the current charge status. Wired Charging: To charge the headset via wired, plug the headset to a USB port with the USB charge cable.

Plug in the USB dongle and launch NGENUITY. Click on the Headset tab. Click "Install" on the "Audio Drivers Required" prompt. Wait until the drivers are finished installing. Click "Ok, Will Do" on the "drivers Installed" prompt. Restart your PC.

Setting up with PlayStation 4 1. Connect the wireless USB adapter to the PlayStation 4 console. 2. Set Input Device to USB Headset (HyperX Cloud Alpha Wireless) 3. Set Output Device to USB Headset (HyperX Cloud Alpha Wireless) 4. Set Output to Headphones to All Audio 5. Set Volume Control (Headphone