HyperX Clutch Gladiate Calibration Mode

If you are experiencing drifting or issues with the analog sticks or triggers, Calibration Mode will allow you to re-calibrate the analog sticks and triggers.

Enter Calibration Mode

1. Press and hold View Button + Menu Button + Xbox Button
​

​

2. While holding the buttons above, plug in the USB cable to power on the controller

3. LED will rapidly blink continuously, showing that it is in Calibration Mode

Perform Calibration
While in Calibration Mode

1. In a full circular motion, slowly rotate both analog sticks at its furthest distance. Repeat this step for a total of 3 times.

2. Fully press and release both Left Trigger and Right Trigger. Repeat this step for a total of 3 times.

There are no LED indicators if the calibration steps were performed correctly or incorrectly. If unsure calibration steps were performed incorrectly, please repeat the “Perform Calibration” steps again.

Exit Calibration Mode
1. Press both Y and D-Pad Down at the same time to save and exit Calibration Mode.

2. The LED will turn off for 3 seconds and then power on with a solid LED.