HyperX Support Center
Knowledge Base Articles
Knowledge Base Articles
Technical Specifications Headset Transducer type: Dynamic 53mm Operating principle: Closed Frequency response: 15Hz-25KHz (earphones) Nominal impedance: 60 ohm per system Nominal SPL: 98+/-3dB T.H.D: < 2% Power handling capacity: 150mW • Sound coupling to the ear: Circumaural Ambient noise attenuati
Knowledge Base Article
•
Cloud
Overview A. Leatherette headband B. Headband adjustment slider C. Leatherette ear cushions D. Detachable noise cancellation mic E. Cable with in line audio control
Knowledge Base Article
•
CloudX
The headset and USB adapter are automatically paired together out of the box. But if the manual pairing is needed, follow the steps below to pair the headset and USB adapter. 1. While the headset is powered off, hold down the power button until the headset status LED starts blinking red/green rapidl
Knowledge Base Article
•
Cloud Core Wireless DTS
Usage with Mobile Device (Phone or Tablet) To use the HyperX Cloud headset with a mobile device, simply plug the “Y” cable into the 3.5mm audio jack as seen below. (NOTE: Location of the audio jack may vary based on the model and/or brand of mobile device you are using.) The volume of the conversati
Knowledge Base Article
•
Cloud
Setting up with PlayStation 4 1. Set Input Device to USB Headset (HyperX Cloud II Wireless) 2. Set Output Device to USB Headset (HyperX Cloud II Wireless) 3. Set Output to Headphones to All Audio 4, Set Volume Control (Headphones) to maximum
Knowledge Base Article
•
Cloud II Wireless
1. Set Input Device to USB Headset (HyperX Cloud Core Wireless) 2. Set Output Device to USB Headset (HyperX Cloud Core Wireless) 3. Set Output to Headphones to All Audio 4. Set Volume Control (Headphones) to maximum level.
Knowledge Base Article
•
Cloud Core Wireless DTS
Cloud Mini Wireless Using with Mobile Devices *Requires 3.5mm headset jack with standard CTIA connection or compatible 3.5mm adapter.
Knowledge Base Article
•
Cloud Mini Wireless
Cloud II Wireless Quick Start Guide
Knowledge Base Article
•
Cloud II Wireless
Cloud Core Usage with Mobile Device (Phone or Tablet) To use the HyperX Cloud Core headset with a mobile device, plug the 3.5mm jack directly into the headset jack on your phone or tablet.
Knowledge Base Article
•
Cloud Core