Cloud MIX

Cloud MIX Specifications Headphone Driver: Custom dynamic, 40mm with neodymium magnets Type: Circumaural, closed-back Frequency response: 10Hz–40,000Hz Impedance: 40 Ω Sound pressure level: 100dBSPL/mW at 1kHz THD: < 2% Weight: 260g Weight with mic: 275g Cable length: Detachable headset cable: 1.3m

Wired headset setup 1. Connect the detachable microphone to the headset’s microphone port. Push until the microphone sits flush. 2. Connect the 3.5mm cable plug with the grey portion into the headset’s cable port. Push until you feel a click and there is no visible grey portion. 3. Connect the oppos

In-line controller Rotate the volume wheel to increase/decrease the volume. Slide the microphone mute switch up or down to mute/unmute the microphone. The red mark on the switch indicates that the mic is muted

Cloud Mix User Manual

Please make sure the detachable headset cable is securely connected to the headset. To ensure the cable is properly connected, first disconnect the cable from the headset and then firmly reconnect the cable ensuring it is completely attached.

A. 3.5 mm Cable Port B. Microphone Port C. USB Charge Port D. Bluetooth Power Button E. Status LED F. Bluetooth Volume Buttons G. Bluetooth Multifunction Button H. Bluetooth Microphone I. USB Charge Cable J. Detachable Microphone K. 3.5mm Cable L. Wired Microphone Mute M. Wired Headphone Volume Whee

Headset charging When the headset is connected to a charger with the USB charge cable, the status LED will indicate the charge status. The headset will take approximately 3 hours to charge fully. Status LED indicators The status LED on the headset indicates the current state of the headset.

The Cloud Mix supports AptX and AptX Low Latency. It does not support AptX HD or AptX Adaptive.

To perform a factory reset on the headset, hold the power button and volume up button together for 7 seconds. The status LED will flash blue 5 times and light up red for 1 second. The headset will turn off automatically.

Wireless headset setup through Bluetooth® Bluetooth pairing With the headset turned off, press and hold the power button for 5 seconds. The LED indicator will flash red and blue. On your Bluetooth-enabled device, search and connect to HyperX Cloud MIX. Once connected, the indicator LED will flash bl