HyperX Support Center
Knowledge Base Articles
Knowledge Base Articles
Move slider to unlock or reduce trigger motion
Knowledge Base Article
•
Clutch Talon
A. Analog Sticks (L3/R3) B. Xbox Button C. Power LED D. ABXY Buttons E. View Button F. D-Pad G. Share Button H. Menu Button I. Trigger Locks (3 way) J. P2/P3 Buttons K. Connection Switch L. 3.5mm Headset Jack M. P1 Button N. Bumpers (LB/RB) O. Triggers (LT/RT) P. USB-C Port Q. Mobile Clip Connector
Knowledge Base Article
•
Clutch Talon
Clutch Talon Quick Start Guide
Knowledge Base Article
•
Clutch Talon
LED Solid White: Connected Blinking White: Searching for USB Wireless Dongle
Knowledge Base Article
•
Clutch Talon
Assign/Reassign P2 and P3 Double Press P1. LED will blink Magenta While LED is blinking Magenta, press a button to assign. While LED is fast blinking Magenta, press either P2 or P3 to assign your selected button. Led will blink Green for success, blink Red for invalid selection. Clear individually P
Knowledge Base Article
•
Clutch Talon
Set the controller to Xbox or 1k mode and hold down the P1 button for 10 seconds. Press the pinhole connect button on the usb dongle.
Knowledge Base Article
•
Clutch Talon
Toggle the switch to 1k polling mode on the controller
Knowledge Base Article
•
Clutch Talon
HyperX Clutch Talon Factory Reset Press and hold P1+P2+P3 buttons for 5 seconds The LED will blink white and red when completed *This will clear the Bluetooth paired devices and P2/P3 custom mapping
Knowledge Base Article
•
Clutch Talon
Set the controller to Bluetooth mode. Device #1 Press P1 Button Device #2 Press P1 + P2 Buttons Device #3 Press P1 + P3 Buttons
Knowledge Base Article
•
Clutch Talon