DuoCast

​​ PC Setup Connect the microphone to a USB port on the PC or Mac with the included USB cable Windows To ensure the microphone is configured correctly on the PC, follow the steps below: Right-click on the sound icon on the system tray and select Sounds. On the Playback tab, select Speakers HyperX Du

​​ Push the multifunction button to switch between the microphone’s two polar patterns, indicated by the LED ring. LED Ring - Full to Front - Cardioid LED Ring Front to Full - Omnidirectional

To turn microphone monitoring on/off, press and hold the multifunction button and tap the tap-to-mute sensor.

Remove both the thumb screw and nut from the microphone stand. Remove the microphone stand from the microphone. Align the mount adapter with the microphone mount holes and secure the adapter with the thumb screw and nut.

DuoCast Quick Start Guide

​ Connect headphones to the headphone jack on the microphone for microphone monitoring and playback audio.

Notes: Improved brightness level and behavior of certain light effects DuoCast Firmware Updater Version 4109 6113

A. Tap-to-Mute Sensor B. LED Ring C. Gain Control Knob D. Multifunction Button E. Headphone Output F. USB-C Port G. USB-C to USB-A Cable H. Mount Adapter (Supports both 3/8" and 5/8" thread sizes)

​​ Tap the tap-to-mute sensor to mute/unmute the microphone. The LED ring will toggle to indicate the change in mute status.

If you are experiencing any issues, we recommend trying to Factory Reset the microphone. Hold the tap-to-mute sensor and the multifunction button until the LED ring flashes red for about 8 seconds. This will indicate the reset was successful.