Microphone

Articles - Category Page

  • HyperX SoloCast 2 Pro Mounting Instructions

    SoloCast 2 Pro can be used with a Microphone stand or arm with either 3/8" or 5/8" threads.

    Knowledge Base Article

  • HyperX FlipCast Filter Switches

    150Hz High-Pass filter: On- Green ​ Switching on the high-pass filter reduces out rumble or other unwanted low frequencies. The high-pass filter has a cutoff frequency of 150Hz and a roll-off of 12dB/octave. Presence Boost: On - Green ​ Switching on the presence boost enhances upper-mid frequencies,

    Knowledge Base Article

  • HyperX QuadCast Connecting Headphones

    ​ Connect headphones to the headphone jack on the microphone for microphone monitoring and playback audio.

    Knowledge Base Article

  • HyperX QuadCast 2 S Connecting Headphones

    *HyperX Cloud III Wired Not Included ​

    Knowledge Base Article

  • HyperX DuoCast Factory Reset

    If you are experiencing any issues, we recommend trying to Factory Reset the microphone. Hold the tap-to-mute sensor and the multifunction button until the LED ring flashes red for about 8 seconds. This will indicate the reset was successful.

    Knowledge Base Article

  • HyperX QuadCast 2 S Positioning Microphone

    QuadCast 2 S should be placed with the front of the microphone facing the sound source. The side with HyperX logo is the front side. ​

    Knowledge Base Article

  • HyperX Procast Quick Start Guide

    Procast Quick Start Guide

    Knowledge Base Article

  • How to Connect Headphones to the HyperX SoloCast 2 Pro

    Connect headphones to the 3.5mm headphone jack on the microphone for microphone monitoring and playback audio.

    Knowledge Base Article

  • HyperX ProCast Connecting Instructions

    Please ensure that phantom power is powered off before connecting or disconnecting the microphone. ​​ 1. Use an XLR cable to connect the microphone's output to a balanced XLR input with phantom power. ​​ 2. Switch the XLR input's phantom power on. Phantom power is required for the HyperX ProCast to

    Knowledge Base Article

  • HyperX FlipCast XLR Connection

    Use an XLR cable to connect the microphone's output to a balanced XLR omicrophone input. Phantom power is not required and should be switched off.

    Knowledge Base Article