Microfono

FlipCast Quick Start Guide

When the microphone is not muted and no level adjustements are being made, the LED bar will show the microphone's level meter. Press the multifunction wheel to cycle between adjustment modes. Microphone Gain Headphone Volume * Monitor/Playback Mix* *USB connection only. 3.5mm connection required for

The HyperX FlipCast can be used with a micrphone stand or arm with either 3/8" or 5/8" threads. To use with 5/8" threads, use a coin to remove the pre-installed 3/8" thread adapter. Rotate the stand mount nut clockwise to attach the microphone. Adjust the desired position before tightening the nuts,

Tap-to-Mute Sensor: White - Mute Off Red - Mute On

A. Tap-to-mute sensor B. Gain control knob C. Polar pattern knob D. Headphone jack E. USB-C port F. USB cable G. Mount adapter* *Supports both 3/8” and 5/8” thread sizes

HyperX SoloCast 2 Pro Quick Start Guide

A. Tap-to-Mute Sensor B. LED ring C. Multifunction control D. 3.5mm headphone port E. USB-C port F. USB-C to USB-C cable G. USB-C to USB-A adapter

Impostazioni SoloCast PS4 ​​ ​ Collega il microfono a una porta USB della PS4™ tramite il cavo USB in dotazione. Per assicurarti che il microfono sia configurato correttamente sulla PS4™, segui i passaggi sottostanti: Dal menu principale di PS4™, vai su Impostazioni > Dispositivi > Dispositivi audio

150Hz High-Pass filter: On- Green ​ Switching on the high-pass filter reduces out rumble or other unwanted low frequencies. The high-pass filter has a cutoff frequency of 150Hz and a roll-off of 12dB/octave. Presence Boost: On - Green ​ Switching on the presence boost enhances upper-mid frequencies,

PC - The Quadcast's mic monitoring can be disabled by going to Control Panel>Sound>Recording. Select the HyperX microphone and click Properties. Select the Listen tab and then disable "Listen to this device." The Quadcast S can be adjusted through Ngenuity under the Mic monitoring feature MAC - Open