Cloud Stinger 2 Wireless

The headset and wireless adapter are automatically paired together out of the box. But if manual pairing is needed, follow the steps below to pair the headset and wireless adapter. 1. While the headset is off, hold the power button until the headset status LED starts blinking red/green rapidly. 2. W

Headset status Tone Notification Power On - 1 tone (mid) Power Off - 2 tones (high, low) Maximum volume reached - 3 tones (high) Minimum volume reached - 3 tones (low) Low battery (10%) - 4 tones (mid, low, mid, low) Microphone muted - 2 tones (high, high) Microphone active - 1 tone (high) Mic monit

1. Plug in the wireless dongle and launch NGENUITY 2. Click on the Headset tab 3. Click “Install” on the “Audio Drivers Required” prompt 4. Wait until the drivers are finished installing 5. Click “OK, Will Do” on the “Drivers Installed” prompt 6. Restart your PC

1. Connect the wireless adapter to the PlayStation 5 console. 2. Go to the home page and select Settings > Sound 3. Under Microphone, set the following: Input Device: USB Headset (HyperX Cloud Stinger 2 Wireless) 4. Under Audio Output, set the following: Output Device: USB Headset (HyperX Cloud Stin

Cloud Stinger 2 Wireless Quick Start Guide

1. Connect the wireless adapter to the PC. 2. Power on the headset. 3. Right click speaker icon > Select Open Sound settings > Select Sound Control Panel 4. Under the Playback tab, click on “HyperX Cloud Stinger 2 Wireless” and click on the Set Default button. 5. Under the Recording tab, click on “H

Operation ​ Cloud Stinger 2 Wireless microphone positions

Headphone Driver: Dynamic, 50mm with Neodymium magnets Form factor: Closed Back Frequency response: 10 Hz - 20.2 kHz Impedance: 32 Ω Sensitivity: 104.5 dBSPL/mW at 1 kHz T.H.D.: ≤ 2% Frame type: Plastic Ear cushions: Memory foam and premium leatherette Microphone Element: Electret condenser micropho

A. Swivel to mute microphone B. Status LED C. Power button D. USB-C charge port E. Volume wheel F. USB wireless adapter G. Wireless pairing pin hole H. Wireless status LED I. USB-C charge cable

1. Connect the wireless adapter to the PlayStation 4 console. 2. Set Input Device to USB Headset (HyperX Cloud Stinger 2 Wireless). 3. Set Output Device to USB Headset (HyperX Cloud Stinger 2 Wireless). 4. Set Output to Headphones to All Audio. 5. Set Volume Control (Headphones) to maximum.