Cloud Alpha 2 Wireless

Performing a hardware reset on the headset will do a soft reset on all the internal hardware. This may be useful if the headset has unusual behavior, such as unresponsive controls. To perform a hardware reset, press and hold the mic mute button and the multifunction button for 5 seconds. The headset

NGENUITY should automatically swap back to the hardware audio endpoints when the software and audio engine are not running. Check Windows sound settings and make sure the following devices are assigned correctly to the hardware endpoints: Default playback device: Headphones (HyperX Cloud Alpha 2 Wir

NGENUITY requires administrative permission to install the drivers. With default User Accoount Control settings, you should receive a pop-up for "DriverInstaller". You will need to click "Yes" for the drivers to install. You may also need to adjust User Account Control settings.

Cloud Alpha 2 Wireless - Firmware v124 Change log Resolved an issue where devices failed to communicate properly with NGENUITY after resuming from sleep mode. Fixed a bug where lighting settings were not being saved on DAC keys. Addressed issue where Bluetooth functionality could fail when charging

Single Press: Play / Pause, Answer Call Double Press: Skip Track, End Call, Reject Call Triple Press: Previous Track Long Press (2 seconds): Activate Voice Assistant Note: Button functionality can vary between devices and apps.

1. Slide the headset wireless mode switch to the WiFi symbol and the base station mode switch to "HEADSET". 2. Power ON the headset.

Make sure that the HyperX Audio Drivers are installed. Check Windows sound settings and make sure the following devices are assigned correctly: Default playback device: NGENUITY -- 8 Channel Spatial Default playback communications device: NGENUITY -- Chat Default recording device: NGENUITY -- Microp

Performing a factory reset on the headset will reset the headset and base station to default settings and remove pairing info with paired Bluetooth devices. To perform the factory reset from the headset side: Press and hold the power button and the multifunction button for 10 seconds to initiate fac

1. While the headset is powered off, hold down the power button for about 10 seconds until the headset status LED starts blinking white rapidly. The headset is now in pairing mode. 2. While the base station is plugged in and the base station output mode switch is set to headset, hold the top 3 butto

Use cable to connect the headset and devices directly with 3.5mm jacks.