Clutch Talon

Assign/Reassign P2 and P3 Double Press P1. LED will blink Magenta While LED is blinking Magenta, press a button to assign. While LED is fast blinking Magenta, press either P2 or P3 to assign your selected button. Led will blink Green for success, blink Red for invalid selection. Clear individually P

Move slider to unlock or reduce trigger motion

LED Solid White: Connected Blinking White: Searching for USB Wireless Dongle

Connect the controller to console or system using the USB dongle, USB cable or via Bluetooth connection.

LED Status Solid Blue : Connected Blinking Blue: Searching Fast Blinking Blue: Pairing Bluetooth Connections Device #1 Single Press P1 (Blink Once) Device #2 Single Press P1 + P2 (Blink Twice) Device #3 Single Press P1 + P3 (Blinke 3 Times)

HyperX Clutch Talon Factory Reset Press and hold P1+P2+P3 buttons for 5 seconds The LED will blink white and red when completed *This will clear the Bluetooth paired devices and P2/P3 custom mapping

Set the controller to Xbox or 1k mode and hold down the P1 button for 10 seconds. Press the pinhole connect button on the usb dongle.

​ LED Charging Status Blinking Red: Low Battery Breathing Amber: Charging Solid White: Fully Charged

Set the controller to Bluetooth mode. Device #1 Press P1 Button Device #2 Press P1 + P2 Buttons Device #3 Press P1 + P3 Buttons

Toggle the switch to 1k polling mode on the controller