Cloud III S Wireless

Slide the mode switch to the Bluetooth icon. Press and hold the Power and Multifunction buttons for 2 seconds to enter Bluetooth pairing mode. Pairing mode is active when the LED blinks blue and the voice prompts says "Bluetooth pairing". ​ ​Go to your device Bluetooth settings, search, and connect

While the headset is powered off and in adapter mode, hold down the power button until the headset status LED starts blinking white rapidly. The headset is now in pairing mode. While the USB wireless dongle is plugged in, use a small tool (e.g. paper clip, SIM tray ejector, etc.) to hold down the bu

Power off the headset. Carefully pull the right ear cushion from the headset. Unscrew the 4x Phillips screws to separate the driver cover from the right earcup. Gently separate the cover from the earcup to avoid any damage. Locate and remove the battery secured with the connector. Place new battery

Connect the USB wireless dongle to your device. Set headset mode switch to the WiFi icon. Power on the headset. To ensure the headset is configured correctly on the PC, follow the steps below. Right-click on the sound icon in the system tray and select Sound Settings. Set the output device to Speake

Cloud III S Wireless Quick Start Guide

简而言之：如果您的无线网卡在 PS5 或其他系统上无法工作，但在其他设备上却可以正常工作，请使用外接电源的 USB 集线器。必须是外接电源的集线器。如果仍然遇到问题，请联系我们。 护理团队。 如果您有一款无线产品（特别是耳机），它通过无线 USB 适配器连接，并且您尝试将其与 PS5 一起使用，您可能会遇到 PS5 似乎无法识别 USB 的问题。 将USB适配器插入PS5后，适配器上的LED指示灯应该亮起。如果指示灯不亮，则表明适配器无法正常工作。 然而，这可能并非加密狗本身的问题。主机端最近对USB接口的改动可能导致USB接口供电过高，进而导致USB加密狗进入安全模式。部分主机型号仅在前置U

Performing a factory reset on the headset will reset the headset to default settings, remove pairing info with paired Bluetooth devices, and remove pairing info with OMEN Instant Pair. Press and hold the Power button and Multi-function button for 10 seconds to initiate factory reset. The power statu

Locate the Wireless Module. Open the OMEN laptop screen. Identify the wireless receiver module located on the top right corner of the screen bezel. Set the Headset to Adapter Mode. Slide the connection mode switch on the headset to WiFi mode. With the headset in Adapter mode, hold down the power but

*This method is only possible if the OMEN laptop has already previously paired with a compatible Instant Pair headset. Open the NGENUITY software. Go to the Settings tab. Under “Connected Hardware,” select HyperX Wireless Embedded Receiver. Click Pair new headset to set the OMEN system in pairing mo

Connect the USB wireless dongle to your device. Set headset mode switch to the WiFi icon. Power on the headset. To ensure the headset is configured correctly on the PS5, follow the steps below: Go to the home page and select Settings > Sound. Under Microphone, set the following: Input Device: USB He