Cloud Orbit

PlayStation 4 USB Setup 1. Power on the headset. 2. Hold down the microphone volume wheel for 2 seconds to change audio modes. Repeat this step until the headset plays the voice prompt “2 Channel”. 3. Connect the headset to the PlayStation 4 console with the USB Type-C to USB Type-A cable. 4. From t

PC USB Setup 1. Power on the headset. 2. Connect the headset to the PC with the USB Type-C to USB Type-A cable. 3. Right click speaker icon > Select Open Sound settings > Select Sound control panel 4. Under Playback tab, click on “HyperX Cloud Orbit” and click on Set Default. 5. Under Recording tab,

The USB port the headset is plugged into may not be supplying enough power. Additionally, some PC USB ports may not supply power in "sleep mode" and/or other power-saving modes. Lastly, if the USB charging mode is disabled on the Cloud Orbit, the headset will not charge through USB until the headset

Cloud Orbit Specifications Headphone Driver: Planar transducer, 100 mm Type: Circumaural, Closed back Frequency response: 10Hz–50,000Hz Sound pressure level: >120 dB T.H.D.: < 0.1% (1 kHz, 1 mW) Weight: 368g Cable length: USB Type-C to USB Type-A: 3m USB Type-C to USB Type-C: 1.5m 3.5mm plug (4-pole

Sidetone on the Orbit headset can be disabled by turning down the microphone volume level until a low double beep plays through the headset. The sidetone feature can be enabled again by turning up the microphone volume until a single beep plays through the headset. *The Orbit software can also be us

Cloud Orbit Analog 3.5mm Mode 1. Power on the headset 2. Connect the headset to the device’s 3.5mm port with the 3.5mm (4-pole) cable