Mikrofon

FlipCast Quick Start Guide

When the microphone is not muted and no level adjustements are being made, the LED bar will show the microphone's level meter. Press the multifunction wheel to cycle between adjustment modes. Microphone Gain Headphone Volume * Monitor/Playback Mix* *USB connection only. 3.5mm connection required for

The HyperX FlipCast can be used with a micrphone stand or arm with either 3/8" or 5/8" threads. To use with 5/8" threads, use a coin to remove the pre-installed 3/8" thread adapter. Rotate the stand mount nut clockwise to attach the microphone. Adjust the desired position before tightening the nuts,

Tap-to-Mute Sensor: White - Mute Off Red - Mute On

A. Tap-to-mute sensor B. Gain control knob C. Polar pattern knob D. Headphone jack E. USB-C port F. USB cable G. Mount adapter* *Supports both 3/8” and 5/8” thread sizes

HyperX SoloCast 2 Pro Quick Start Guide

A. Tap-to-Mute Sensor B. LED ring C. Multifunction control D. 3.5mm headphone port E. USB-C port F. USB-C to USB-C cable G. USB-C to USB-A adapter

Ustawienia SoloCast PS4 ​​ ​ Podłącz mikrofon do portu USB w konsoli PS4™ za pomocą dołączonego kabla USB. Aby mieć pewność, że mikrofon jest prawidłowo skonfigurowany na konsoli PS4™, wykonaj poniższe czynności: W menu głównym PS4™ przejdź do Ustawienia > Urządzenia > Urządzenia audio. Ustaw urządz

150Hz High-Pass filter: On- Green ​ Switching on the high-pass filter reduces out rumble or other unwanted low frequencies. The high-pass filter has a cutoff frequency of 150Hz and a roll-off of 12dB/octave. Presence Boost: On - Green ​ Switching on the presence boost enhances upper-mid frequencies,

PC - The Quadcast's mic monitoring can be disabled by going to Control Panel>Sound>Recording. Select the HyperX microphone and click Properties. Select the Listen tab and then disable "Listen to this device." The Quadcast S can be adjusted through Ngenuity under the Mic monitoring feature MAC - Open