Cloud Stinger 2 Wireless

The headset and wireless adapter are automatically paired together out of the box. But if manual pairing is needed, follow the steps below to pair the headset and wireless adapter. 1. While the headset is off, hold the power button until the headset status LED starts blinking red/green rapidly. 2. W

1. Plug in the wireless dongle and launch NGENUITY 2. Click on the Headset tab 3. Click “Install” on the “Audio Drivers Required” prompt 4. Wait until the drivers are finished installing 5. Click “OK, Will Do” on the “Drivers Installed” prompt 6. Restart your PC

Cloud Stinger 2 Wireless Quick Start Guide

1. Connect the wireless adapter to the PC. 2. Power on the headset. 3. Right click speaker icon > Select Open Sound settings > Select Sound Control Panel 4. Under the Playback tab, click on “HyperX Cloud Stinger 2 Wireless” and click on the Set Default button. 5. Under the Recording tab, click on “H

A. Swivel to mute microphone B. Status LED C. Power button D. USB-C charge port E. Volume wheel F. USB wireless adapter G. Wireless pairing pin hole H. Wireless status LED I. USB-C charge cable

Headphone Driver: Dynamic, 50mm with Neodymium magnets Form factor: Closed Back Frequency response: 10 Hz - 20.2 kHz Impedance: 32 Ω Sensitivity: 104.5 dBSPL/mW at 1 kHz T.H.D.: ≤ 2% Frame type: Plastic Ear cushions: Memory foam and premium leatherette Microphone Element: Electret condenser micropho

​ Status LED Status Battery Level LED Searching: Slow breathing green Connected: 90% - 100% Solid green for 5s 10% - 90% Blinking green for 10s < 10% Blinking red for 10s *Battery level indication *The status LED will automatically turn off to conserve battery life Power Button • Hold for 3 seconds

​ Audio Controls Volume Microphone Mic monitoring DTS:X Spatial Sound On: Spatial sound is enabled. DTS APO communicates directly with games/apps and renders best spatial sound possible. Off: Spatial sound is disabled. Stereo sound is played through headset. Equalizer 10 band equalizer Includes EQ p

LED Charge Status ​

1. Connect the wireless adapter to the PlayStation 4 console. 2. Set Input Device to USB Headset (HyperX Cloud Stinger 2 Wireless). 3. Set Output Device to USB Headset (HyperX Cloud Stinger 2 Wireless). 4. Set Output to Headphones to All Audio. 5. Set Volume Control (Headphones) to maximum.