Cloud III S Wireless

Slide the mode switch to the Bluetooth icon. Press and hold the Power and Multifunction buttons for 2 seconds to enter Bluetooth pairing mode. Pairing mode is active when the LED blinks blue and the voice prompts says "Bluetooth pairing". ​ ​Go to your device Bluetooth settings, search, and connect

While the headset is powered off and in adapter mode, hold down the power button until the headset status LED starts blinking white rapidly. The headset is now in pairing mode. While the USB wireless dongle is plugged in, use a small tool (e.g. paper clip, SIM tray ejector, etc.) to hold down the bu

Power off the headset. Carefully pull the right ear cushion from the headset. Unscrew the 4x Phillips screws to separate the driver cover from the right earcup. Gently separate the cover from the earcup to avoid any damage. Locate and remove the battery secured with the connector. Place new battery

Connect the USB wireless dongle to your device. Set headset mode switch to the WiFi icon. Power on the headset. To ensure the headset is configured correctly on the PC, follow the steps below. Right-click on the sound icon in the system tray and select Sound Settings. Set the output device to Speake

Cloud III S Wireless Quick Start Guide

簡而言之：如果您的無線網路卡在 PS5 或其他系統上無法運作，但在其他裝置上卻可以正常運作，請使用外接電源的 USB 集線器。必須是外接電源的集線器。如果仍然遇到問題，請聯絡我們。 護理團隊。 如果您有一款無線產品（特別是耳機），它會透過無線 USB 轉接器連接，並且您嘗試將其與 PS5 一起使用，您可能會遇到 PS5 似乎無法識別 USB 的問題。 將USB轉接器插入PS5後，轉接器上的LED指示燈應該會亮起。如果指示燈不亮，則表示適配器無法正常運作。 然而，這可能並非加密狗本身的問題。主機端最近對USB介面的改變可能導致USB介面供電過高，進而導致USB加密狗進入安全模式。部分主機型號僅在

Performing a factory reset on the headset will reset the headset to default settings, remove pairing info with paired Bluetooth devices, and remove pairing info with OMEN Instant Pair. Press and hold the Power button and Multi-function button for 10 seconds to initiate factory reset. The power statu

Locate the Wireless Module. Open the OMEN laptop screen. Identify the wireless receiver module located on the top right corner of the screen bezel. Set the Headset to Adapter Mode. Slide the connection mode switch on the headset to WiFi mode. With the headset in Adapter mode, hold down the power but

*This method is only possible if the OMEN laptop has already previously paired with a compatible Instant Pair headset. Open the NGENUITY software. Go to the Settings tab. Under “Connected Hardware,” select HyperX Wireless Embedded Receiver. Click Pair new headset to set the OMEN system in pairing mo

Connect the USB wireless dongle to your device. Set headset mode switch to the WiFi icon. Power on the headset. To ensure the headset is configured correctly on the PS5, follow the steps below: Go to the home page and select Settings > Sound. Under Microphone, set the following: Input Device: USB He