Headset

Overview A. Leatherette headband B. Headband adjustment slider C. Leatherette ear cushions D. Detachable noise cancellation mic E. Cable with in line audio control

Status Adapter Mode Dual Mode Pairing Fast blinking white Fast blinking blue Searching Blinking white Blinking purple Connected Solid-fade white for 5 seconds Solid-fade purple for 5 seconds

Make sure that the HyperX Audio Drivers are installed. Check Windows sound settings and make sure the following devices are assigned correctly: Default playback device: NGENUITY -- 8 Channel Spatial Default playback communications device: NGENUITY -- Chat Default recording device: NGENUITY -- Microp

Cloud Stinger 2 Wireless User Manual

Scroll up or down to adjust the volume wheel

Manually Pairing the Headset and USB Adapter The headset and USB adapter are automatically paired together out of the box. But if the manual pairing is needed, follow the steps below to pair the headset and USB adapter. 1. Power on the headset 2. While the USB adapter is plugged in, use a small tool

Cloud Revolver S USB Audio Control Box operation The USB Audio Control Box has the following features: Dolby® Surround 7.1 audio technology 3 preset equalizer modes Microphone Mute Headphone volume adjustment Microphone volume adjustment

Cloud Stinger 2 Core Specifications Headphone Driver: Dynamic, 40mm with neodymium magnets Form factor: Over ear, circumaural, closed back Frequency response: 10 Hz – 25 kHz Impedance: 32.5 Ω Sensitivity: 95 dBSPL/mW at 1 kHz T.H.D.: ≤ 2% Frame type: Plastic Ear cushions: Soft foam & fabric Micropho

Usage (Xbox One) To use the headset with Xbox One™, connect the 3.5mm plug on the headset directly to the 3.5mm jack on the Xbox One controller * If your Xbox One controller does not have a 3.5mm jack you will need the Xbox One Stereo Headset adapter (sold separately) that plugs into the Xbox One co

1. Plug in the wireless dongle and launch NGENUITY 2. Click on the Headset tab 3. Click “Install” on the “Audio Drivers Required” prompt 4. Wait until the drivers are finished installing 5. Click “OK, Will Do” on the “Drivers Installed” prompt 6. Restart your PC